Welcome to my blog

Welcome to my blog and thank you for visiting today, I hope you will stay a while. Slide shows are at the bottom of this page. Follow my blog with Bloglovin


Wednesday 1 April 2009

Craft Robo blues - again!

I need my Robo to cut out a big 50, I am no good at cutting by hand, but I have a new PC with Vista and though I downloaded the Vista software with drivers the drivers will not install on my PC.

I have emailed Graphtec who are trying to help, but they seem to think it is down to my inability to point to the drivers, I keep telling them I can't point to what isn't there! They are going to send me the drivers on a disk as they said it might be easier for me to point at them, though they have talked many people through pointing at the drivers in the past - arghhhhh, there are no drivers to point at - how many times!!!!!!

I was expecting problems with installing on Vista and I wasn't wrong, shame as I need it now.

1 comment:

  1. so sorry to here that!
    I have a Robo and also on vista, have no trouble with it.
    Hope you get it sorted.

    ReplyDelete

Thank you so much for your comment, I love to hear from you. Your comment will appear in a little while when I moderate it.

You might be seeing a verification thingy here, but I have verification turned off and I believe that you will be able to ignore the verification and just leave a comment anyway! Go on - try it.